Developer Replacement - Ricoh Robin Service Manual

24 June 1994

3.3 DEVELOPER REPLACEMENT

[A]
1. Take out the development unit (2 screws).
2. Set the development unit on a large sheet of paper [A].
3. Remove the toner supply unit (2 screws). (See Toner Supply Unit
Removal.)
4. Empty all the developer onto the paper making sure that no developer
remains on the development roller or in the unit.
NOTE: Dispose of the used developer according to local regulations.
5. Take one pack of developer [B], shake it well, and pour it into the
development unit while rotating the gears [C] on both sides to distribute
the developer evenly as shown.
NOTE: When installing new developer or manually rotating the
development roller, always make sure to turn the gears in the
direction shown in the above diagram. The copier might be
damaged if they are turned in the opposite direction.
6. Reinstall the toner supply unit and set the development unit in the
machine.
7. Perform the initial setting for new developer using SP65.
DEVELOPMENT AND TONER SUPPLY
[C]
5-27
[B]
[C]