Ricoh Robin Service Manual page 141

24 June 1994
2.7.2 Wire Installation
[2]
[B]
1. Put the bead at the end of the dark silver wire [1] in slot [A].
2. Put the bead of the light silver wire [2] in slot [B].
3. Wind the dark silver wire [1] clockwise half a turn around the pulley. Wind
the light silver wire [2] clockwise one complete turn around the pulley.
4. Wind the dark and light silver wires together five and a half times around
the pulley. Make sure that the dark silver wire is wound six times and the
light silver wire is wound six and a half times in total.
5. Set the omega clamp [C] over the wires on the drive pulley [D] as shown.
[1]
[A]
[1]
[2]
5-15
[C]
[3]
[4]
OPTICS
[D]