Ricoh Robin Service Manual page 192

24 June 1994
[D]
[C]
[A]
9. Remove the front [A] and rear [B] pressure springs.
10. Remove 1 C-ring [C] and 1 bearing [D] (front side).
11. Remove the relay gear [E] (1E-ring).
12. Slide the hot roller [F] to the rear.
13. Replace the hot roller (2 C-rings [H, I], 1 gear [J], 1 bearing [K]).
14. Install the new hot roller.
NOTE: a) Peel off 3 cm (1 inch) from both ends of the protective sheet
on the new hot roller before installing it.
b) Before reinstalling the pressure springs, remove the rest of the
protective sheet.
c) Before reinstalling the pressure springs, refer to the Fusing
Pressure Adjustment Section.
[F]
[E]
[I]
[K]
5-67
FUSING
[B]
[H]
[J]