Ricoh Robin Service Manual page 138

OPTICS
8. Install a new lamp [A]. Use a strip of paper as shown to hold the lamp.
Set the front terminal [B] first.
NOTE: a) Make sure that the exposure lamp is properly positioned at the
front and rear [C] terminals.
b) Make sure that the blister [D] on the lamp is pointing straight
up as shown.
c) Return the first scanner to the original position and make sure
that the first scanner moves smoothly.
d) Clean the optics components and perform the necessary SP
modes (SP95, 48, and 56).
[C]
[D]
[A]
[D]
5-12
24 June 1994
[B]