Section 2.1
Before
You Begin
Section 2.2
Required Tools
and Equipment
Section 2.3
Compliance to
European Union
Directives
Chapter 2
Installation and Wiring
This chapter tells you how to:
•
Determine the power requirements for the modules
•
Avoid electrostatic damage
•
Install the module
•
Wire the module's terminal block
•
Wire input devices
Have the following tools and equipment ready:
•
Medium blade or cross-head screwdriver.
•
Thermocouple or millivolt analog input device.
•
Shielded, twisted-pair cable for wiring (Belden™ 8761 or equivalent for
millivolt inputs, or shielded thermocouple extension wire for
thermocouple inputs).
•
Controller (for example, a MicroLogix™ 1500 or CompactLogix™
controller).
•
Programming device and software (for example, RSLogix 500™ or
RSLogix 5000™).
This product is approved for installation within the European Union and EEA
regions. It has been designed and tested to meet the following directives.
2.3.1 EMC Directive
The 1769sc-IT6I module is tested to meet Council Directive 2014/30/EU
Electromagnetic Compatibility (EMC) and the following standards, in whole or
in part, documented in a technical construction file:
•
EN 61131-2 Programable controllers, Part 2 - Equipment requirements
and tests.
User's Manual Pub. 0300244-02 Rev. A
Need help?
Do you have a question about the 1769 Series and is the answer not in the manual?