Chapter 11. Disk-Diskette Management Functions - IBM 3745 Service Functions

o
o
o
D
1. When the disk-save on a diskette is com-
pleted, you get the message:
DISK SAVE ONTO xxxxxxx DISKETTE COMPLETED.
2. Remove the diskette.
3. Press SEND.
4. You return to screen
B,
to create the next
diskette.
S. After the fifth diskette, you go to screen
D.
1. Take note of the date and identifiers.
Write them on the diskette or diskette cover
for later identification.
2. Press SEND.
3. You return to screen
B.
Note: The 'INTERNAL 10' field is an identification
entered at the creation of the diskette, and is used
for checking during a restore.
Disk Save Error Message
If an error occurs, this message is displayed:
DISK ERROR. SAVE CANCELLED
1. Press F6 or F1.
2. Refer to "Hard Disk Trouble Analysis and
Replacement" on page 11-19 for further
action.
Save Disk
SAVE DISK ONTO DISKETTES
DISK SAVE ONTO PRIMARy DISKETTE COMPLETED.
(or) DISK SAVE ONTO SECONDARY DISKETTE COMPLETED.
(or) DISK SAVE ONTO THIRD DISKETTE COMPLETED,
(or) DISK S"VE ONTO FOl.RTH DISKETTE COMPLETED.
(or) DISK SAVE ONTO FIFTH DISKETTE COMPLETED.
(and)
REMOVE DISKETTE. THEN PRESS SEND
Fl :END F3:ALARM
Figure 11-6. Save Disk Function Diskette Copy End
Screen
o
SAVE DISK ONTO DISKETTES
01 SK CORRECTlY SAVED • TAKE NOTE OF F OLLOIII NG I NFOR."A TI O~j:
DATE
=
xx(xx/xx (r+1/DD/H)
EC
SAVE I D : xxxxxxxx
INTERNAL
10 :
xxxx'xxx
THEN PRESS SEND
Fl :ENO F3:ALARM
Figure 11-7. Save Disk Function End Screen
SAVE DISK ONTO DISKETTES
DISK ERROR. SAVE CANCElLED
F3:ALARM
Figure 11-8. Save Disk Function Mount Diskette Screen
Chapter 11. Disk-Diskette Management Functions
11-7