Display/Delete Messages - IBM 3745 Service Functions

'0
0
11
II
I
l
I
D
I I
D
Display/Delete Messages
DELETE NOT ALLOWED FOR THIS FILE
Cause: The operator tned to delete a file not
In
the delete list of files obtained by pressing F6.
Action: None.
DISK ERROR
Cause: A physical disk error occurred when attempting to access a given file.
Action: Change the disk.
EMPTY
Cause: The associated file contains no data. This can occur only with dump files.
Action: None.
END OF DATA
Cause: The microcode attempted to read/wnte the last sector plus one of the file (to complete the screen data).
Action: None.
END OF FILE
Cause: The microcode attempted to read/write the last sector of the file.
Action: None.
FILE NOT FOUND
Cause: The operator specified a file name which does not eXIst.
Action: Check the file name entered against the file names listed, and retry.
INVALID INPUT
Cause: The operator specified a wrong Item l1umber (out of the Window specified on the screen), or a data address which IS not
a hexadeCimal string.
Action: Enter a valid Item number, or a valid hexadeCimal string.
MODULE NOT FOUND
Cause: The operator specified a module name which does not eXIst.
Action: Check for module name validity.
OUT OF FilE
Cause: The operator specifIed a data address out of the fIle lImIt.
Action: SpecIfy a data address inside the fIle limit.
REFRESH MODE, PRESS BREAK TO STOP
Cause: The operator has entered 'refresh' mode by pressing SEND twice.
Action: Press the BREAK (or ATTN) key to leave 'refresh' mode. Take care to press thiS key when the console IS unlocked
(between two data refreshes).
SELECT A FilE
Cause: The operator has not entered a file name, but has pressed SEND.
Action: Enter a valid file name and press SEND again.
TOP OF FilE
Cause: The operator has pressed F7 (backward), or has entered a data address which reaches the top of the file.
Action: None.
UNDEFINED F KEY
Cause: The operator has pressed a key not specified as active on the screen.
Action: None.
The following messages are for internal use only. If you receive one of them, contact the PE:
• ALREADY OPENED
• BAD A(AREA)
• BAD COUNT
• BAD MODULE TYPE
• BAD PLiST
• BUF OVFLW
• INPUT ONLY
Chapter 6. Displaying Dumps, Storage and Modules, and Deleting Files
6-11