IBM 3745 Service Functions page 243

_. __
._-_._---------_
...
- - - - _ .
Restore Disk
Step 2: Copy the Diskettes
1. Mount the primary diskette.
2. Press SEND.
3. The following messages are displayed:
RESTORE DISK FROM xxxxxxx DISKETTE IN
PROGRESS
then
RESTORE DISK FROM xxxxxxx DISKETTE COMPLETED
(xxxxxxx can be: PRIMARY, SECONDARY,
THIRD, FOURTH, or FIFTH).
4. Repeat this step for the five diskettes.
5. Screen
m
is displayed.
Use of F1
If you press Fl before getting that screen, you
set MOSS down, and the disk contents will not
be valid.
This screen is displayed when the five diskettes
have been successfully checked (they bear the
same ID) and restored on the disk.
1.
Power the 3745 OFF, then ON.
2. Refer to the 3745 Installation Guide,
SY33-2067, to perform the following actions:
a. IML the MOSS from the disk, at the control
panel.
If you have used a "virgin" set of backup
diskettes, perform the next steps; otherwise,
stop here.
b. Enter the customer password. (All default
passwords are IBM3745, but the mainte-
nance password is not defined.)
c. Update and activate the maintenance
password.
3. Ask the customer to update the password(s),
as needed.
Disk Restore Error
DISK ERROR. FUNCTION CANCELLED
1. Press Fl.
II
RESTORE DISK FROM DISKETTES
t~OUNT
PRIMARY DISKETTE. THE'I PRESS SEt,D
Fl :END F3:ALARM F6:QUIT
Figure 11-14. Restore Disk Function, Mount Primary
Diskette Screen
CI
RESTORE DISK FROM DISKETTES
DISK CORRECTLY RESTORED
POIIER OFF THEN pallER ON THE 37<15
PERFORM MOSS IML FROM CONTROL PANEL IIITH FUtlCTlON 1
Fl :END F3:ALARM F6:QUIT
Figure 11-15. End of Restore Disk Function Screen
2. Refer to "Hard Disk Trouble Analysis and Replacement" on page 11-19 for further action.
11-10
3745
Service Functions
c
;r--
I
.~