IBM 3745 Service Functions page 96

1
1,1
o
o
o
, , "''IT flII,ww,jNMi+,nll'f11 ""UflD!!+'Y.I!"lilil L'W '
Hi
lv"9",,,. (""tiM" 'III!HHIfI'Lb!.tI ' hWH I '11
!iLL!JJ
Checkpoint Trace
Scanner Checkpoint Trace
The checkpoint trace is always ready to start at the same time as the SIT trace. Use the SIT function
to stop the checkpoint trace.
1. You must be in the TSS function (see 4-4).
2. Select function 9 (details page 4-4).
3. Enter the values in
0, fJ,
and
D·
4. Press SEND.
The screen gives all the details about the entries.
No 'Screen Description' is provided for this proce-
dure.
D
SELECT/RELEASE I
DUMP/lML I
3 MODE CONTROL I - ENTER A DECIMAL LINE ADDRESS FROM
e
TO 1939
DPLY/ALT STORE I (TSS:
e
TO 895. HPTSS: 1024 TO 1039)
DPLY/ALT BLOCKSI
6 DPLY/ALT LSR I - ENTER T FOR TRANSMIT. R FOR RECEIVE
OPLY/AlT XREG I
ADDRESS COMPARE I
CHK-POINT TRACE I - ENTER ON OR OFF
10 OPLY/ALT HPTSS I
ON - CHECKPOINT TRACE IIILL START IIITH
SCANNER INTERFACE TRACE (SIT)
OFF - CHECKPOINT TRACE NOT EFFECTIVE
===> ENTER ANY INTERFACE:RELEASE/SELECT SCANNER IS AUTO~1ATIC
F1 :END F2:MENU2 F3:ALARM
o
B
Figure 4-29. Scanner Checkpoint Trace Selection
Screen
Chapter 4. Transmission Subsystem (TSS) Functions
4-19