IBM 3745 Service Functions page 218

o
o
o
o
D
Display CA and Interface Status
CA and Interface Display
In screen
0
of "Selecting CAS Functions" on
page 10-2, select 1. This screen is displayed.
CA Statuses
INTERNAL STATUS
RESET
ERRCKOUT
ERRINIT
ERRCHAIN
ERRTPS
INIT
***
I I!I'IL \ n i l L HI! lell! I n l ! J I
IYILII'lllll1'd
J
CA/lnterface Status
I!I
CA INTER~~AL LOGICAL TRACE INTERFACE E/O UHERFACE
NBR STATUS STATUS ACTIVE Nur:SER REel-EST STAlLS
INlT DISCONNECTEO YES
RESET CONNECTED
ERRC~OUT I NOPERATI VE
I NIT CONNECTED YES
FI?ENO F3?ALARM
IA
2A
3A
4A
5A
6A
7A
BA
F6?OUIT
Figure 10-4. CA and Interface Status Screen
CA not present or TPS installed.
ENABLED
DISABLED
DISABLED
ENABLED
The CA has been reset by a 'Power ON/reset' signal
and the result of the checkout is OK.
The checkout result after a 'power ON/reset' signal is
not OK.
An error occurred during the CA initialization.
An error occurred during CA chaining process at IPL
time.
TPS conflict between CDF and hardware.
The CA has been successfully initialized.
The status is unknown.
LOGICAL STATUS (CA status from the control program point of view)
NA
INOPERATIVE
CONNECTED
DISCONNECTED
DOWN
***
The control program is not loaded.
At IPL time, and due to an internal status of OFF or
ERRxxxxx, this CA will be indicated as inoperative to
the control program.
At IPL time, and when the internal status is INIT, this
CA will be indicated as operative to the control
program.
The CA is now owned by the MOSS.
An error occurred during a normal operation.
The status is unknown.
Chapter
10.
CA
Services
1 0-3