IBM 3745 Service Functions page 75

Diagnostic Messages
Diagnostic Messages
Note: This section only gives the messages associated to the diagnostic requests or the diagnostic
selection.
For specific information on diagnostic routines, refer to the Diagnostic Descriptions.
BREAK RECEIVED
Cause: The BREAK key has been pressed.
Action: None.
CHECK RPO PROCEDURE, PRESS SEND TO CONTINUE, OR C TO CANCEL
Cause: Manual routine A TOS has been called.
Action: BE CAREFUL: If you press SEND, the machine will be powered OFF.
RUN IPL PHASE 1 ON ASSOCIATED CCU, THEN TRY AGAIN
Cause: You tried to run the concurrent diagnostics on an Idle CCU.
Action: I P L the CCU, then cancel the I P L when It reaches phase 1.
1FT 10
NOT ALPHABETIC
Cause: The first letter of your request IS not alphabetic.
Action: Enter the correct 1FT Id.
INVALID REPLY
Cause: A reply other than A, C, R, G, or M has been entered, or the M option IS invalid, when an error IS found by diagnostics.
Action:
Enter a valid reply.
INVALID REQUEST
Cause: The requested diagnostic cannot run
In
this environment, or does not eXIst.
Action:
Enter a valid request.
INV. REQ. PARM.
Cause: A wrong parameter (ADP, LINE) has been entered.
Action:
Enter a valid parameter.
INV. REQ. PARM. 2
xx -
NOT INSTALLED OR PWR OFF
Cause: The selected adapter IS not Installed.
Action: Select a valid adapter.
INV. OPT. PARM.
Cause: A wrong option has been entered.
Action:
Enter a valid option.
NOT IN ALLOWED RANGE
Cause: Parameter not In range.
Action: Enter a valid parameter.
NOT INSTALLED
Cause: Selected adapter or line not Installed.
Action:
Enter a valid adapter or line.
RFC ... CANNOT BE REPORTED ... CHJGDOVG LOADING FAILED
Cause: Program loading not possible (dlsk/DFA error).
Action:
refer to RAC code.
ROUTINE 10 NOT HEXA VALUE
Cause: Requested routine not In hexadeCimal value.
Action:
Enter with correct hexadeCimal value.
ROUTINE READY TO START
Cause: DCF has initialized and loaded diagnostics.
Action: Select an action.
3-26
3745 Service Functions
(
(
i
~,
(