Establishing A Connection Between Client Pc And Router; Displaying Connection Status - MB Connect Line mbNET Series Manual

Establishing a connection between client PC and router


Router Internet dial-in. Depending on the router settings (see Internet Configuration), you need to either
restart the router, or push the Reset button.
For further Internet dial-in settings, please see section

Client PC Internet dial-in. Dial the client PC into the Internet.

Transmit IP address:
For the client to be able to access the router, it must know the
router's IP address. The option to transmit the IP address is se-
lected during router configuration. The IP address is identified by
sending it to the email address specified during configuration.
As the router IP address changes each time it dials up to the Internet, a helpful alternative is to use
our DynDNS service.
For information on setting up and using the MB Connect Line DynDNS service,
please see section

Displaying connection status

–
Go to Status Internet
connection.
For further information about the status messages, read the chapter: Status
Page 66 of 237
Version: 5.1.6 – June 4
th
, 2019
Network – DynDNS
to check if there is an internet
Network – Internet
messages