Checking The Configuration On Multiple Access Points - Cabletron Systems RoamAbout Access Point Manual

Checking the Configuration on Multiple Access Points

Checking the Configuration on Multiple Access Points
The AP Manager provides integrity tests that check for consistent settings across all the
Access Points in a single group. Use the integrity tests to make sure that the Access Points
in a single wireless network are configured correctly. To access the tests, click Integrity
on the AP Manager menu bar.
The Parameters option tests that all Access Points are configured with the following:
•
Same bridge mode
•
Same wireless network name
•
Different station name
•
Same AP Density setting
•
Same transmit rate
•
Same Secure Access setting
•
Same RTS Threshold
•
Same rate limiting setting
•
Same upline dump setting
•
Same forwarding setting
Values not used in LAN-to-LAN mode are not checked when the Access Point is in
LAN-to-LAN mode.
The Firmware Revisions option verifies that all Access Points have the same version of
the firmware.
The additional menu item, Link Test, is used to test the communications quality between
the Access Point and another wireless device.
5-30 Configuring the Wireless Network