Showing Current Access Point Settings - Cabletron Systems RoamAbout Access Point Manual

Showing Current Access Point Settings

Before modifying parameters on the RoamAbout Access Point, view the current settings.
Using the AP Manager, select the Access Point from the Managed List field and click the
various buttons, such as Wireless Parameters, Operating Modes, IP Network
Parameters, and Hardware. In the Wireless Parameters dialog box, click the Advanced
button to view all the wireless parameters. If you have changed any wireless parameters and
have not yet reset the Access Point, both the operating (current) settings and the settings
that take affect after the next reset are displayed.
Using the console port RoamAbout Access Point Installation Menu, choose Show Current
Settings to display the current Access Point settings as shown below.
=================================================================
RoamAbout Access Point CSIWS, Wireless Bridge: HW=V2.2,RO=V1.7,SW=V6. 00
SysUpTime
SNMP Read/Write Community
Console Password
SNMP Trap Addresses
Wired MAC Address
IP Address
Subnet Mask
Default Gateway
Wireless MAC Address
Wireless Network Adapter
Adapter Revisions
Encryption Capabilities
Bridge Mode
Upline Dump
Memory
===================================================================
Showing Current Access Point Settings
: 00:26:37
: public
: Disabled
: Not Configured
: 08-00-2B-A3-89-61
: 16.20.40.156
: 255.0.0.0
: Not Configured
: 00-60-6D-92-00-FB
: RoamAbout IEEE 2.4 GHz DS 11 Mbit
: Hardware 4.000 Firmware 4.00
: 128 bit
: Workgroup
: DISABLED
: 16777216 bytes
Press Return for Main Menu ...
Configuring the Wireless Network 5-19
98 resets