Using The Access Point Leds To Determine The Problem; Access Point 2000 Leds - Cabletron Systems RoamAbout Access Point Manual

Using the Access Point LEDs to Determine the Problem

Using the Access Point LEDs to Determine the Problem
The Access Point LEDs show status and help diagnose problems. The following sections
describe the LEDs on the Access Point 2000 and the original release of the Access Point.
The following figure shows the two Access Points.
Figure 7-1: RoamAbout Access Points
Access Point 2000

Access Point 2000 LEDs

Table 7-1 describes the function of each of the LEDs. Error conditions cause the LEDs to
turn on, off, or blink in a pattern. Table 7-2 describes the patterns, the most likely causes,
and possible corrective actions. Table 7-3 describes the LED patterns during an Access
Point firmware upgrade. If you suspect an Access Point failure, run the self-test by
removing then reapplying AC power.
7-2 Problem Solving
1
1
2
Original Access Point