Cabletron Systems RoamAbout Access Point Manual page 77

10. Set the Bridge Mode to LAN-to-LAN Endpoint. This configures the Access Point to
communicate with only one Access Point.
11. In the Wireless Parameters dialog box, enter the wireless MAC address of the remote
Access Point.
12. The default transmit rate setting works well in most environments. To modify this
setting, see the "Configuring the Transmit Rate" section on page 5-23.
13. The default RTS Threshold setting works well in most environments. To modify this
setting, see the "Configuring the RTS/CTS Protocol" section on page 5-24.
14. To use data encryption, use the procedure in the "Setting Encryption" section on page
5-27.
15. To implement your changes, select Reset from the main window, then select Reset
with Current Settings. Allow approximately one minute for the Access Point to reset
and complete its self-test.
16. Repeat this procedure at the other Access Point.
Configuring Access Points in a Point-to-Point Network
Configuring the Wireless Network 5-11