Using The Access Point Hardware Reset Button - Cabletron Systems RoamAbout Access Point Manual

Upgrading the RoamAbout Access Point Firmware and ROM

Using the Access Point Hardware Reset Button

The Reset button on the Access Point hardware forces the Access Point to download a
firmware image and reset to factory default values.
!
CAUTION
To use the Reset button:
1. Remove AC power from the Access Point.
2. Restore AC power then press the Reset button on the Access Point. If an image is not
available, the Access Point waits approximately three minutes then resets to factory
default values.
6-14 Maintaining the Wireless Network
If the power is interrupted during the ROM upgrade process,
the image in your device will become corrupt. Do not turn
off or perform any action that can cause power loss during a
ROM upgrade.