Table of Contents
Advertisement
12. To prevent other users from using the console port to view or modify settings, enable
Enable/Disable Console Password from the Installation Menu. Then choose Set
SNMP Read/Write Community from the Installation Menu and enter a new
community name (4 to 31 printable ASCII characters). Users must enter the
community name to access the menu.
13. To implement your changes, reset the Access Point by selecting Reset with Current
Settings from the Installation Menu. Allow approximately one minute for the Access
Point to reset and complete its self-test.
14. Perform this procedure on the other Access Points.
Configuring the Access Point for Point-to-Multipoint
Configuring the Wireless Network 5-17
Advertisement
Table of Contents
Need help?
Do you have a question about the RoamAbout Access Point and is the answer not in the manual?