Changing The Isa Adapter Address; Setting And Removing Snmp Trap Addresses - Cabletron Systems RoamAbout Access Point Manual

Changing the ISA Adapter Address

If the device conflict is related to the I/O port address of the ISA card, you can change the
ISA address by changing the jumper setting on the ISA card (Figure 7-3). The ISA card
supports two I/O addresses:
•
3E0-3E1 (factory-set default)
•
3E2-3E3
To change the jumper setting, open your computer according to the documentation that was
shipped with your computer and follow the safety precautions described in the RoamAbout
installation documentation that came with the ISA adapter.
Figure 7-3: ISA Card I/O Address Strapping

Setting and Removing SNMP Trap Addresses

To have the Access Point send SNMP traps, you need to enter the IP address of the device
where the trap is to be sent. A trap is a defined event or condition detected by the
RoamAbout Access Point SNMP agent. The Access Point sends an SNMP trap when any
of the following events occur:
•
Access Point is powered on (coldstart trap).
•
Ethernet network connection is established (network link up trap).
•
User tried to communicate with the Access Point using an incorrect SNMP community
string (authentication trap).
Setting and Removing SNMP Trap Addresses
Problem Solving 7-29