Showing Current Client Settings - Cabletron Systems RoamAbout Access Point Manual

Showing Current Client Settings

To view or modify the RoamAbout client parameters, open the driver properties as follows:
1. From the Windows desktop, click Start then select Settings → Control Panel. Double
click the Network icon.
Alternately, right-click on Network Neighborhood on your desktop then select
Properties from the menu.
2. For Windows 95 or 98, the Network dialog box is displayed. Click on RoamAbout
802.11 DS to highlight it, then click the Properties button.
3. For Windows NT, click the Adapters tab. In the Network Adapters field, click on
RoamAbout 802.11 DS to highlight it, then click the Properties button.
The RoamAbout Properties window (Figure 5-1) appears. On a Windows NT system,
the Driver Type and Bindings tabs are not present and an Adapter tab is displayed.
The Driver Type tab lists which RoamAbout driver is used with the PC Card. The
Bindings tab lists the available network protocols. The protocols with a check mark
are associated with the PC Card.
The Adapter tab lists the PC Card I/O Base Address and the Interrupt Request (IRQ)
value. You can change these values if the RoamAbout PC Card uses the same I/O Base
Address or IRQ as another device in the computer.
Press <F1> on the keyboard for information about the RoamAbout Properties window.
4. At an Apple PowerBook system, open the Apple menu, select Control Panels then
select RoamAbout Setup.
Showing Current Client Settings
Configuring the Wireless Network 5-21