Selecting The Location For A Single Access Point - Cabletron Systems RoamAbout Access Point Manual

Infrastructure Network
Figure 3-1: Coverage Area
A RoamAbout Access Point can support up to 250 users within its coverage area. However,
this number can be significantly reduced by various factors, such as noise or obstructions
in the coverage area, and the network utilization by each client. If your desired coverage
area is larger or the number of users is greater, you need to install multiple Access Points.
Be aware of potential hidden station problems. If possible, arrange the coverage area to
minimize or prevent any two clients from being within range of the Access Point, but out
of range from each other.

Selecting the Location for a Single Access Point

The Access Point should be placed as close as possible to the center of the planned coverage
area. If it is necessary to install the Access Point in an obstructed location, use the optional
Range Extender antenna to extend the coverage area of the Access Point. The Range
Extender antenna should also be used if, for security reasons, you need to install the Access
Point in a closed location, such as a closet. Before mounting the Access Point, review the
hardware requirements described in the installation documentation that came with the
RoamAbout Access Point.
For best placement, configure the Access Point and a client and use the procedure in the
"Optimizing RoamAbout Access Point Placement" section on page 6-6 before permanently
mounting the Access Point.
Designing and Implementing a Wireless Network 3-3