Setting Upline Dump - Cabletron Systems RoamAbout Access Point Manual

Setting Upline Dump

To enter an SNMP trap address using the console port:
1) Choose Add SNMP Trap Addresses from the RoamAbout Access Point
2) Enter the IP address of the system that you want to receive the SNMP traps.
Note: If you do not want to change the existing value, press <Enter> to go back to the
previous menu.
To delete an existing trap address using the console port:
1) Choose Delete SNMP Trap Addresses from the RoamAbout Access Point
2) Enter the IP address of the system that you no longer want to send SNMP
Note: If you do not want to change the existing value, press <Enter> to go back to the
previous menu.
Setting Upline Dump
The Upline Dump mode is disabled by default. This option allows you to specify whether
the Access Point uploads diagnostic information bout itself in the event of a crash. This
option should be DISABLED unless a support representative tells you otherwise.
The Upline Dump setting is available by clicking the Operating Modes button in the AP
Manager, or selecting the Module-Specific Options in the console port RoamAbout
Access Point Installation Menu.
When enabled, you can select one of the following:
•
Use the BootP Server to discover the IP address of the destination TFTP server and the
destination directory on that server.
•
Upload the image to the specified TFTP server IP address and a destination directory.
NOTE
Depending on the dump host, you may need to create a writable file to accept the dump.
The file name should be apxxxxxx.dmp, where xxxxxxx is the last 6 digits of the Access
Point's wired MAC address.
7-30 Problem Solving
Installation Menu.
Installation Menu.
traps.
You must use the path structure dictated by your operating system.