Figure B
Assembly
Before operating the machine it must be
completely assembled. Prior to beginning
the assembly process refer to Needed for
Setup and gather the listed items. First
clean all of the parts that are coated in
heavy-duty rust preventative.
Caution!
Band saw blades and parts are sharp. Wear
heavy leather gloves for protection
1. Attach the (4) rubber feet to the
machine base. (Figure C) these rubber
feet simply press onto the corners of
the base.
Figure C
2. Loosen the Scale indicator and turn
it downwards, then remove the
table lock lever, flat washer, table
Figure D
3. Turn the guide post adjustment knob
4. Remove the wing bolt, lock washer, flat
5. Using the gap in the table (Figure E),
.
Figure E
11
tilt adjustment knob, and shoulder
bolt with spring. (Figure D)
(Feg.3) counterclockwise and raise the
guide post all the way up.
washer, and D-nut from the table
assembly for reinstallation later.
slide the table assembly through the
blade and rotate the assembly 90 deg.
Position the assembly as shown in
(Figure F).