Power Supply - Craftex CX Series User Manual

AVAILABILITY OF POWER
Before Installation of this machine you will
need to consider the proximity of your
power supply circuit. If available circuits do
not meet the requirements for this machine
you will have to get a new circuit installed by
a licensed electrician. Use of a licensed
electrician will minimize the risks of fire,
electrocution, damage to equipment, and
will insure everything is wired in accordance
to the applicable codes and standards.
FULL LOAD CURRENT RATING
This is the amount of Amps a machine
draws under 100% of the rated output
power.
FULL LOAD RATING FOR 120V
15AMPS
The full load current is not the maximum
amount of amps the machine will draw. The
machine has potential to draw current
beyond the full load rating if it is overloaded.
Overloading of the machine for an extended
period of time can
overheating, or even fire. The risk is higher
if the machine is on an undersized circuit.
To help avoid these issues insure you are
connected to a circuit in which meets the

POWER SUPPLY

cause damage,
7
specified circuit requirements for this piece
of machinery.
WARNING!!!
Do not connect machine to power
before setup has
completed to avoid risk of personal
injury or property damage.
CIRCUIT REQUIREMENTS FOR
CX123 Band Saw
The CX123 has been prewired at the factory
for operation on an electrical circuit that has
a verified ground and meets the below
requirements:
Voltage:
Cycle:
Phase:
Circuit Breaker Size:
Please Note:
1. An electrical circuit includes all electrical
equipment between the breaker panel
and the machine. This is why it is
important to have the proper circuit size
so it can safely accommodate this
machine under full load for an extended
period of time.
2. The circuit requirements laid out in this
manual are for a dedicated circuit in
which only one
operational or installed at a time.
3. If you choose to connect to a shared
circuit where more than one machine
been fully
110V – 120V
60Hertz
Single
15Amps
machine will be