Craftex CX Series User Manual page 16

Test Run
Once you have completely assembled your
machine, test run it to ensure it is properly
connected to the power and all safety
components are functioning properly.
If you encounter a problem during the test
immediately stop the machine, disconnect
it from the power, and fix the problem
before operating the machine again. Check
the Troubleshooting table in the SERVICE
section of this manual for help.
WARNING!
Serious injury or death can result from using
this machine BEFORE understanding its
controls and related safety information. DO
NOT operate or allow others to operate the
machine until the
understood.
WARNING!
DO NOT start the machine until all
preceding setup instructions have been
carried out. Operating an improperly set up
machine may result in a malfunction or
unexpected results that can lead to a
serious injury, death, or machine /property
damage.
1. Clear all tools away from the
machine
2. Connect the machine to the power
supply
information is
16
3. Turn the machine ON, and verify
motor operation, then turn the
machine OFF.
The motor should run smoothly,
without problems
noises.
4. Remove the key, as shown in (Figure
M)
Figure M
5. Try to start the machine with the
ON/OFF paddle switch. The machine
should not start.
 If the machine does not start,
the switch is working as
designed.
 If
the
immediately
machine. The switch is not
working correctly. This is a
safety feature and it must
work
proceeding with operations.
Bade Tensioning
A band saw blade when tensioned correctly
is essential for making accurate cuts and
maximizing blade life. However other
and unusual
machine starts,
stop the
properly before