Craftex CX Series User Manual page 36

If adjustment is required proceed to
the next step.
Figure 15
4. Using a pencil mark both the upper
and lower wheels to indicate your
measuring locations.
NOTE
Marking the wheels will achieve better
more accurate results in case there are any
irregularities in the wheels.
5. Loosen the hex nuts on the rear left
and right adjustment bolts on the
lower wheel bracket.
6. Adjust the left and right bolts by
rotating them until the lower wheel
is coplanar with the upper wheel.
See Figure 16.
Figure 16
7. Retighten the hex nuts loosened it
the previous step.
Blade Wander/Blade Lead
Blade lead is when the band saw blade
wanders away from the cut line when
sawing.
Blade lead can be caused by a dulled,
damaged or worn
tensioned blade, or even using to fast of a
feed rate when making cuts. If your blade is
undamaged and you are still experiencing
blade late perform the following steps.
Figure 17
36
blade, incorrectly