Craftex CX Series User Manual page 12

Figure F
6. Re-install the
removed in step 2. DO NOT fully
tighten yet.
7. Completely raise the upper blade
guide assembly, then
machinist's square flat on the table,
against the side of the blade. (Figure
G)
8. Using the adjustment knob, tilt the
table until the square is flat against
the side of the blade as in (Figure G).
9. Replace the lock lever to secure the
table perpendicular to the blade,
then set the scale indicator to "0" on
the tilt scale and tighten the screw.
components you
place a
12
Figure G
10. Re-install the wing bolt, lock washer,
flat washer, and D-nut (removed in
step 4) on the table assembly.
11. With the fence lock lever in the up
position install the fence on the
fence rail (Figure H). Once the fence
snaps into place, lower the fence
lock lever into the down position.
This will secure the fence to the rail.
Figure H
12. Snap the chip blower nozzle to the
nozzle base (Figure I).