Craftex CX Series User Manual page 14

Figure K
The wheels on this machine has been
factory set, so centre tracking is the only
adjustment that needs to be performed
when the saw is new. This adjustment is
necessary before turning the saw on or
performing other adjustments.
1. DISCONNECT MACHINE FROM
POWER
2. Adjust the upper & lower blade
guides away from the blade, and
raise the upper guides all the way
up. (Refer to Adjusting Blade Guide
Bearings for detailed instructions).
For this test run, the blade must
have approximately
amount of tension as when under
operating conditions. After the test
run is successfully completed, you
will be instructed on how to more
accurately tension the blade for
optimum results.
3. Standing at the rear of the machine,
turn the
clockwise to apply tension to the
blade.
Figure L
4. Open the upper wheel cover.
14
Note:
the same
quick release lever