Fence Assembly - Craftex CX Series User Manual

2.) Loosen the locking knob on the zero
clearance insert. Now remove the
insert, blade guard assembly, and
riving knife.
3.) Find a corner cut on the arbor and
push the red bar into the corner of
the cut as close to the saw blade to
stop the arbor and use the arbor
wrench to loosen the and remove the
arbor nut, flange, and blade. See
Figure 21 below.
Figure 21
NOTE:
To loosen the arbor nut you must turn it
counterclockwise.
4.) Slide the blade on to the arbor with
the teeth facing the front of the saw.
Now reinstall the arbor flange and
nut and tighten them against the
blade. Do not over tighten.
5.) Reinstall the blade guard, riving
knife, and zero clearance table
insert.
WARNING!!!
Always disconnect machine from its
power source
removing saw blades to prevent any
accidental starting
resulting in property damage or serious
personal injury.

Fence Assembly

Aligning the Fence to Be Parallel
With the Blade
1.) Slide the fence over to the edge of
the right T- slot on your table saw
and lock the fence into positon. Now
visually check to see if the the fence
is parallel with the T-slot along the
length of the fence. You can also
take a ¾" block of wood and slide it
up and down the T-slot to check the
distance from the edge of the fence.
See figure 22.
Figure 22
2.) If the fence is not parallel it may be
adjusted by using an allen key to
turn both of the screw C and D. Do
this slowly and only a quarter turn at
a time at most as you will quickly
overshoot the desired adjustment.
See figure 23.
16
when installing or
of the machine