Table of Contents
Advertisement
Installation Guide Linear Motors
In "moving stator" applications, the slider is fixed and the stator is the moving part.
The load is attached to the stator, which is mounted on a linear guide. In order to avoid an overconstrained
bearing mount and compensate for alignment errors, the slider may be mounted on one end in a fixed
bearing with a spherical axial bearing. On the opposite end, the slider is mounted in a floating bearing.
Mounting kits are available for mounting the slider (see the section Slider mounting kits).
3.6.1 Assembling instruction
Please attend to the safety instructions in chapter 2 during the assembling!
If moving stator application is used, the minimum bending radius of the motor cable should
be adhered to. See chapter Cable, section Technical Data.
NTI AG / LinMot
1. Mount stator to its support bearing.
2. Placing a spacer.
3. Insert slider into stator.
P01-23 / P01-37 / P01-48
Put a spacer (wood, plastic, aluminium
with thickness 15 mm) between slider
and linear guide. The spacer prevents
injuries to the hands and damage to
the slider surface!
ENG
Page 11 / 40
Advertisement
Table of Contents
