Parameters Of The Do 16 X Dc 24 V/0.5 A; Table 10-6 Parameters Of The Do 16 X Dc 24 V/0.5 A - Siemens SIMATIC ET 200PA SMART Operating Instructions Manual

ET 200PA SMART I/O modules
10.3 Digital output modules
Technical specifications
● For performance increase
Control of a digital input
Switching frequency
● With resistive load
● With inductive load according to IEC 947-5-1, DC 13
● With lamp load
Internal limiting of the inductive trip voltage to
Short-circuit protection of the output
● Response threshold
Connection of the actuators
10.3.2.1

Parameters of the DO 16 x DC 24 V/0.5 A

Parameter assignment
The parameters are assigned using the parameter assignment dialog of HW Config
Parameters of the DO 16 x DC 24 V/0.5 A
The table below provides an overview of the assignable parameters and their default settings
for the DO 16 x DC 24 V/0.5 A.
The default settings apply when you have not assigned parameters in HW Config or you have
not changed any parameters.
Table 10-6
Parameter
Diagnostic interrupt enable
Diagnostics
● Group diagnostics
● No load voltage L+
Reaction to CPU/master STOP
Substitute value
Group diagnostics
The diagnostics parameter "Group diagnostics" enables the signaling of channel-specific
errors to be switched off, with the exception of parameter assignment errors.
146
Parameters of the DO 16 x DC 24 V/0.5 A
Value range
Yes / No
Yes / No
Yes / No
Substitute a value/
Keep last value
0/1
Not supported
Supported
Max. 100 Hz
Max. 2 Hz
Max. 10 Hz
Typ. L+ (-68 V)
Yes, electronic
Typ. 1.4 A
Using a 40-pin front connector
Default setting Scope
Yes Module
Yes Channel
Yes Channel group
Substitute a Module
value
0 Channel
Operating Instructions, 06/2019, A5E34192013-AB
ET 200PA SMART