Parameters Of The Ai 8 X 12 Bit - Siemens SIMATIC ET 200PA SMART Operating Instructions Manual

ET 200PA SMART I/O modules
10.5 Analog output modules
10.5.1.1

Parameters of the AI 8 x 12 Bit

Parameter assignment
The parameters are assigned using the parameter assignment dialog of HW Config
Parameters of the AO 8 x 12 Bit
You can find an overview of the assignable parameters and their default settings for the
AO 8 x 12 Bit in the following table.
The default settings apply when you have not assigned parameters in HW Config or you have
not changed any parameters.
Table 10-19 Parameters of the AO 8 x 12 Bit
Parameter
Diagnostic interrupt
enable
Diagnostics
● Group diagnostics Yes / No
Output type
Output range
Reaction to CPU
STOP
The diagnostics can be activated on a channel granular basis (parameters: group diagnostics).
When group diagnostics is activated, the module performs a wire break check for current output
and a short-circuit test for voltage output.
Group diagnostics
The diagnostics parameter "Group diagnostics" enables the signaling of channel-specific
errors to be switched off, with the exception of parameter assignment errors.
Wire-break check (only for current outputs)
Use the "Group diagnostics" parameter to activate the wire break check of the current outputs.
In the output ranges 0 mA to 20 mA and ± 20 mA, no "safe" wire break check can be performed
for output values lower than ± 200 µA.
208
Range of values
Yes / No
Disabled
I current
U voltage (as of product version 3)
Voltage from 1 V to 5 V
from 0 V to 10 V
± 10 V
Current from 0 mA to 20 mA
from 4 mA to 20 mA
± 20 mA
ASS Outputs have no current or voltage
LWH Keep last value
Default Scope
Yes Module
Yes Channel
U Channel
± 10 V Channel
(voltage out‐
put type)
ASS Channel
Operating Instructions, 06/2019, A5E34192013-AB
ET 200PA SMART