Otto Bock 50R236 Smartspine SI Instructions For Use Manual page 9

4.1 Selecting the Size
► Select the support size based on the circumference of the pelvis (see size chart).
4.2 Fitting and Application
CAUTION
Incorrect or excessively tight application
Skin irritation due to overheating, local pressure points due to tight application to the body
► Ensure that the support is applied properly and fits correctly.
► Do not use the product in case of a known heat allergy.
When in doubt, do not continue to use the product if skin irritation occurs.
►
CAUTION
Direct skin contact with the product
Skin irritation due to chafing or sweat formation
► Do not wear this product directly on the skin.
NOTICE
Use of a worn or damaged product
Limited effectiveness
► Instruct the patient to inspect the product for proper functionality, wear, and damage pri­
or to each use.
► Advise the patient that the product may not be used if the product or part of the product
exhibits signs of wear (e.g. cracks, deformation, poor fit) or damage.
> The patient is standing.
> The hook-and-loop closure on the abdominal strap is open.
> The pull cable is fully loosened.
1) Optional – inserting the pad: Use the hook-and-loop closure to attach the pad to the inside
of the support (see fig. 1).
2) Guide the support around the body and apply equal force to both sides to pull it forward (see
fig. 2).
3) Attach the right side to the left side of the abdominal strap (see fig. 3). Ensure that the hook-
and-loop sections lie flat against each other and are not in contact with clothing or skin.
4) Pull the end of the pull cable forward and attach it to the abdominal strap with the hook-and-
loop fastener (see fig. 4).
5) Optional – shortening the pull cable: Pull the winding card out of the pocket (see fig. 5),
wrap the pull cable around the winding card (see fig. 6) and put the winding card back into
the pocket.
4.3 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
Clean the support regularly:
1) Fasten all hook-and-loop closures.
2) Hand wash the support in warm water at 30 °C (86 °F) with standard mild detergent.
3) Rinse the support well.
4) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight, stove or radiator).
Ottobock | 9