Table of Contents
Advertisement
Minimal Installation
A minimal configuration can be performed using the Easy Install screen. Once the unit is
installed and minimal configuration is completed, the NOC can complete and verify the
setup.
Procedure
1. Select the Easy Install feature.
Main Menu
main/easy_install
Device Name: Node A
Service Type
Node IP Address:
Node Subnet Mask:
TS Access:
Create a Dedicated Network Management Link
Ethernet Port Options Screen
Network 1 Line Build Out (LBO):
Port 1 Line Build Out (LBO):
---------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
2. Enter the Node IP Address and Subnet Mask.
3. For management:
Set TS Access to DLCI, then select a DLCI on the network interface to be used as
the troubleshooting access link.
– or –
Create a dedicated network management link. Select a DLCI when prompted. The
management link will be used by the NOC to access the unit.
4. If the Ethernet port will be used, select the Ethernet Port Options Screen. Enable
the interface. Respond Yes to the prompt Would you like to set the
Node's Default IP Destination to Ethernet? and configure the
following:
— Enter the IP address and subnet mask for the Ethernet interface.
— Enter the Default Gateway Address (the IP Address that will be used for
packets without a route).
— Press the ESC key to return to the Easy Install screen.
Easy Install
EASY INSTALL
DLCI
Frame Relay
000.000.000.000
000.000.000.000
980
Short
Short
14
9520-ILM
12/13/2002 01:01
Clear
Clear
MainMenu
Exit
Advertisement
Table of Contents
