Setting Up The Isdn Dbm - Paradyne FrameSaver SLV 9126 Installation Instructions Manual

Setting Up the ISDN DBM

FrameSaver 9128 units may be equipped with an ISDN PRI or BRI DBM. These
instructions are for units with ISDN backup capability.
The following guidelines apply:
Central site configuration guidelines:
– Set up the ISDN DBM physical interface.
– If a BRI DBM, change the Automatic Backup Configuration to
Multi_Site_Backup. (A PRI DBM is already configured for multisite backup.)
– Modify the Link Profile(s) that Automatic Backup Configuration created to add a
phone number.
– Configure the unit to answer calls from the remote sites. (A PRI DBM is already
configured to answer calls.)
Remote site configuration guidelines:
– Set up the ISDN DBM physical interface.
– If a PRI DBM, change the Automatic Backup Configuration to
Single_Site_Backup. (A BRI DBM is already configured for single-site backup.)
– Modify the HQ_Site Link Profile that Automatic Backup Configuration created to
add a phone number.
– Configure the remote unit to originate calls to the central site. (A BRI DBM is
already configured to originate calls.)
– Set the criteria by which automatic backup will take place.
Setting Up the DBM Physical Interface
1. Configure the DBM interface.
Main Menu
2. Minimally, set the following configuration options:
– Interface Status is set to Enable.
– Originate or Answer is set to Answer for a central site unit, and set to Originate
for a remote site unit.
– Local Phone Number 1 is entered, plus the following:
FrameSaver Unit with BRI
Configure the B-channels:
Service Profile ID1 (SPID)
Local Phone Number 1
Service Profile ID2 (SPID)
Local Phone Number 2
3. Save the configuration and return to the ISDN menu.
Configuration ISDN Physical
FrameSaver Unit with PRI
Configure T1 physical characteristics
to match the service provider's
settings.
Local Phone Number
11