Troubleshooting; Troubleshooting Guide - Stiga Autoclip M3 Operator's Manual

TROUBLESHOOTING GUIDE

The information below is designed to help identify and correct any faults and/or malfunctions which may occur during operation.
Some faults can be fixed by the user, while others require specific technical skills or special expertise and therefore must only be
fixed by qualified personnel with certified experience in the specific field of intervention.
Warning – Caution
Safely stop the robot (see "Robot Safety Stop") in case it is necessary to check the robot, in order to avoid
danger of accidental blade starting.
Problem
Abnormal vibrations
The robot is very noisy
The robot does not position
itself correctly inside the
charging station
The robot does not behave
correctly around the
flowerbeds
The robot works at the wrong
time

TROUBLESHOOTING

Cause
Cutting blade damaged
Cutting blade clogged by residuals
(tape, cords, plastic fragments, etc.)
The robot was started in the presence
of obstacles (fallen branches, forgotten
objects, etc.)
Electric motor failure
Grass too high
Incorrect positioning of the perimeter
wire or power cord of the charging
station
Collapsing of ground next to the
charging station
Perimeter wire laid incorrectly
Clock was set incorrectly
Working time was set incorrectly
29
Remedies
Replace the blade with a new one (see "Blade
Replacement")
Safely stop the robot (see "Robot Safety Stop").
Unclog the blade
Warning – Caution
Use protective gloves to prevent injuries to
your hands
Stop the robot safely (see "Robot Safety Stop")
Remove the obstacle and restart the robot (see
"Start up - Automatic mode")
Have the motor replaced or repaired by your
nearest authorised service centre
Increase the cutting height (see "Adjustment of
cutting height")
Carry out a preliminary cutting of the area with a
normal lawnmower
Check the connection of the charging station
(see "Installation of charging station and power
supply unit")
Position the charging station on a flat and stable
surface (see "Planning of system installation")
Reposition the perimeter wire correctly (counter-
clockwise direction) (see "Installation of
perimeter wire")
Reset the clock of the robot (see "Programming
Mode")
Reset the working time (see "Programming
Mode")
EN
User's manual