Stiga Autoclip M3 Operator's Manual page 32

Problem
EN
The work area is not
completely mowed
Secondary area not
completely mowed
ALERT
Slow orange flashing light
ALERT
Fast orange flashing light
User's manual
Cause
Not enough work hours
Cutting blade clogged with deposits
and/or residuals
Cutting blade worn out
Work area too big compared to the
actual capacity of the robot
The batteries are about to run out.
The batteries do not charge completely
Programming error
Cutting blade damaged
Cutting blade clogged by residuals
(tape, cords, plastic fragments, etc.).
Grass too high
The robot is lifted from the ground
The perimeter wire is not connected
properly (broken cable, no electrical
connection, etc.)
Robot outside the perimeter on a slope
Robot outside the perimeter
Robot inside a flower bed
30
Remedies
Extend the working time (see "Programming
Mode")
Stop the robot safely (see "Robot Safety Stop")
Warning – Caution
Use protective gloves to prevent injuries to
your hands.
Clean the cutting blade
Replace the blade with an original spare part
(see "Blade replacement")
Adjust the work area (see "Technical
specifications")
Replace the batteries with original spare parts
(see "Battery replacement")
Clean and remove any rust from the contact
points of the batteries (see "Robot Cleaning").
Correctly program the secondary area (see
"Programming Mode")
Replace the blade with a new one (see "Blade
Replacement").
Safely stop the robot (see "Robot Safety Stop").
Danger - Attention
Use protective gloves to prevent cutting your
hands.
Unclog the blade.
Increase the cutting height (see "Adjustment of
cutting height")
Check that the robot is not blocked or obstructed
by any object.
Clean and remove any grass residues from
under the body that may block the sensors.
Check the functioning of the electrical power
supply, the correct connection of the power
supply unit and charging station (see "Installation
of charging station and power supply unit").
Mark off the area with too much slope (see
"Planning of system installation")
Check that the wire has been installed correctly
(too deep, next to metallic objects, distance
between the wire marking the two elements
less than 70 cm, etc.) (see "Planning of system
installation")
Reposition the perimeter wire correctly (counter-
clockwise direction) (see "Installation of
perimeter wire").