Preparation And Marking The Boundaries Of The Work Areas - Stiga Autoclip M3 Operator's Manual

PREPARATION AND MARKING THE BOUNDARIES OF THE WORK AREAS

Preparation of the lawn to be mowed
1. Make sure the lawn to be mowed is even and does not contain
EN
holes, stones or other obstacles. If necessary, prepare the
lawn by filling in any holes and removing any obstacles. If
some obstacles cannot be removed, it is necessary to properly
mark these areas with the perimeter wire.
2. The robot can mow surfaces inside the working area with
a maximum slope of 45% (45 cm per meter in length) on a
regular dry lawn, with no risk of wheels slipping, based on
the accessories installed. In the other cases it is necessary to
respect the 35% of the slope.
The perimeter wire must be laid on the ground sloping no more
than 20% (20 cm per meter in length), being in mind that the
robot requires greater grip during the return to the charging
station. Therefore, it necessary to check carefully the lawn
conditions and to respect the limits.
The slope must not increase at least 35cm inside or outside
the perimeter wire. If these instructions should not be complied
with, while the robot is working on sloping areas and detects
the wire, its wheels could slip and make it leave the working
area.
If there are any obstacles on slopes that are closed to the
abovementioned limits, the ground must be uniformed for at
least 35cm in the part uphill of the obstacle to reduce the slope.
Important
Areas with slopes greater than those allowed cannot
be mowed with the robot. Therefore, position the
perimeter wire in front of the slope so that it is
excluded from the area to mow.
0-20%
OK
45 %
100 cm (39,3 ")
User's manual
perimeter wire
45 cm
(17,71 ")
0-45%
21-45%
0-20%
NO
OK
35 cm
(13,78 ")
12
OK
OK
perimeter wire
35 cm
(13,78 ") 0-20%
NO
21-45%
NO