Set Up; Access To The Menu Via App - Stiga Autoclip M3 Operator's Manual

The set up procedure is performed when the robot is started for the first time and after a long period of inactivity.
• Check that the height of the lawn surface to be cut is compatible with the proper functioning of the robot (see "Technical
Specifications").
• Adjust the cutting height as desired (see "Adjustment of Cutting Height).
• Make sure the work area has been correctly marked and that there are no impediments to the regular functioning of the robot
as described in the section "Preparation and Marking of Boundaries of the Work Areas" and following sections.
• Make sure there are no large puddles in the garden due to heavy rain.
• Place the robot inside the charging station.
• Press the ON/OFF key and wait a few seconds for the robot to turn on completely.
• The battery LED turns orange and remains fixed for a few seconds as it recognises the charging station.
• The robot is ready for use. Press the "AUTO" key to set automatic or manual operation.
Operation of the robot in manual mode with "AUTO LED off"
• When the battery is fully charged, press the START/PAUSE key to start the work cycle. When the battery capacity is
exhausted, the robot returns to the charging station.
• If the garden has not been completely mowed, wait until the battery is fully charged and then start a new work cycle.
• For a better result, it is recommended to use the robot at least on every other day.
• To change the default settings of some robot functions, simply download the free application for smartphones; refer to section
"ACCESS TO MENU VIA APP"
Operation of the robot in automatic mode with "AUTO LED on"
• When in automatic mode, the robot is scheduled to work every day of the week from 12:00pm to 4:30pm (GMT+1) for the
Autoclip M3 model and from 10:00am to 7:00pm (GMT+1) for the Autoclip M5 model.
• The number of work cycles is managed automatically by the robot based on the battery capacity. In automatic mode, the
robot exits the charging station to perform the work cycle and returns to recharge itself, and if necessary, to resume working
again.
• To change the default settings of the working time and other functions, simply download the free application for smartphones,
refer to paragraph "ACCESS TO MENU VIA THE APP"
The robot has a built-in Bluetooth device that allows it to be programmed and controlled using a smartphone.
Using a smartphone or tablet, download the application from Google Play or the Apple Store by searching for "Stiga Remote."
Start the application and follow the wizard to pair the Robot to your device.
The factory set PIN is "0000." Change the PIN as soon as possible to make the robot safe.
The application allows you to:
• Change the automatic standard working time.
• Set the operation of the rain sensor.
• Set the departure points to optimally manage the secondary area.
• Change the password.
• Send the Start / Pause / Home command.
• Guide the robot during the cutting.
• Display the status, alarms and any errors of the robot.

SET UP

ACCESS TO THE MENU VIA APP

21
EN
User's manual