Work Schedules - Programming Mode - Stiga Autoclip M3 Operator's Manual

Important
To get the best out of the robot, it is recommended to program the robot to work every day.
WORK SCHEDULE 1: function for setting the first time of the robot's working day.
The cursor automatically positions itself in the area under the first time (e.g. 10:00am to 1:00pm). Set the time for the start and
end of the work.
Setting the time at "00:00 – 00:00" means that the robot will not work during Work Schedule 1. Once entered. If the entered time
is wrong such as if the time overlaps with the working time 2 or if the starting time is after the end time, the robot beeps and
resets the set value.
WORK SCHEDULE 2: function for setting the second time of the robot's working day.
Important
If it is necessary to set secondary areas, then it is preferable to program both work schedules in order to
increase the mowing frequency of the area.
The setting of the time is essential for the robot's proper functioning. Many parameters influence the setting of the work schedules,
such as the number of secondary areas, the number and the power of batteries of the robot, complexity of the lawn, type of grass,
etc. Generally, the working hours must be increased slightly when mowing gardens with secondary areas, with lots of obstacles
and complicated areas. Below is a table with the indicative times for configuring the robot on first use.
NB. Set all the weekdays at "1" – "Work Days."
Model
Autoclip M3
Autoclip M5
WORKING DAYS: Allows activating the working days of the week.
Important
To get the most out of your robot, it is recommended to program it robot to work every day.
EDGE CUTTING: activates edge cutting mode. It is recommended to leave the set default frequency.
WORK SCHEDULES – PROGRAMMING MODE
m² (ft²)
150 (1615)
300 (3230)
400 (4304)
500 (5380)
Time 1
11:00 12:00
11:00 12:00
10:00 16:00
10:00 19:00
23
EN
Time 2
15:00 16:00
User's manual