Adjusting Water To Syrup Ratio (Brix); Converter Block - lancer 2308 Series Installation And Service Manual

1.10 ADJUSTING WATER TO SYRUP RATIO (BRIX)

A. Hold the brix cup under the syrup separator and activate valve. Check ratio (brix).
B. To obtain the proper ratio, use screwdriver to adjust syrup flow control (see Figure 2).
C. Remove syrup separator.
D. Install diffuser and nozzle.
E. Slide ID panel DOWN.
F. Repeat process for each valve.
NOTE: When re-assembling valves with o-rings, ensure the o-ring is lubricated with an FDA-
approved lubricant or water to prevent leakage or damage to the o-ring.

1.11 CONVERTER BLOCK

A. Set the converter block to provide either plain or carbonated water, depending on the product.
The alignment of the dot on the converter block signifies the active port (plain water or
carbonated water):
B. To remove the converter block, use a small screwdriver in the blind hole to pry the converter
block out. Applying pressure opposite the blind hole (dot side) will facilitate removing the
converter block:
7 P.N. 28-0720/05