Table of Contents
Advertisement
4.8.4
Submenu Firmware Download
The firmware required for the MAGIC EEC Switch is always included in the
PC software. Via the Firmware Download the firmware can be comfortably
loaded on the system.
With the Browse button you select the firmware file. The file is always stored
in the directory in which you installed the MAGIC EEC application. The
standard installation directory is:
The name of the firmware file is „EEC.ssw".
FIG. 26
Please press the Start button to load the firmware on your system. The
Progress bar shows the status of the download. After about three minutes
the download will be finished. If the download had been successful, a mes-
sage is displayed. After a confirmation the system executes a reset.
NOTE
If a download had been faulty, you can simply switch off the unit and then
switch it on again. The new software is only written in the flash memory, if a
download had been successful. Otherwise the old firmware is maintained.
W i n d o w s
C:\Programme\MAGIC EEC
FIRMWARE DOWNLOAD
P C
S o f t w a r e
P A G E 5 3
Advertisement
Table of Contents
