Table of Contents
Advertisement
4.7.2.3.4
SNMP Parameter
To integrate the MAGIC EEC into a network management system, the SNMP
function can be used.
FIG. 17
Under SNMP Parameter the function can be activated by enabling the option
SNMP.
Please ask your network management system administrator for the correct
SNMP settings.
• First you need to select which SNMP Version you use. Currently SNMP
v1 and v2c are supported.
• The Read Community entry is an identifier to read data. The name has to
be identical with the name in your Management System. By default, the
name public is used.
• Under Trap Community you define the name for the trap datagrams. The
name has to be identical with the name in your Management System.
• Please enter the port on which MAGIC AD1 ETI receives messages under
SNMP Port. The default setting is usually Port 161.
• MAGIC EEC allows the addressing of up to four different Network Man-
agement Systems. Please enter the corresponding IP addresses and Ports
under NMS 1 (IP Adr./Port), NMS 2 (IP Adr./Port), NMS 3 (IP Adr./Port)
and NMS 4(IP Adr./Port).
• Under System Description you can assign a name for MAGIC EEC.
• Under Contact an email address can be entered.
• Under System Location you can enter the location of the switch.
NOTE
The settings System Description, Contact and System Location are values
of the standard System Group in RFC1213 MIB-II (if SNMP v1 is used) and
RFC3418 SNMPv2-MIB (if SNMP v2 is used).
W i n d o w s
SNMP PARAMETER
P C
S o f t w a r e
P A G E 4 5
Advertisement
Table of Contents
