Table of Contents
Advertisement
4.5
Operation via the Windows PC Software
In the following chapter all functions of the PC Software are described in de-
tail.
4.5.1
The MAGIC EEC main window - General
After starting the MAGIC EEC Software the main window is automatically
displayed.
The connection status between the PC and the system is displayed in the up-
per right corner of the window:
PC ONLINE: Connection to the PC is ok
PC OFFLINE or NO CONNECTION: Connection to the PC is faulty
The following status messages are also possible:
PC ONLINE ALARM: An alarm has occurred
(see System Monitor)
BOOT MODE: No valid firmware on the system (orange). Please download
the latest software (see CHAPTER 4.8.4)
TIP
If you click on the status message, the System Monitor is displayed which
shows the system status in detail (see CHAPTER 4.9.1).
NOTE
If the connection is faulty, please check the following points:
– Power supply cable is plugged in
– Circuit switch of the system is in the ON position (display is available)
– Network cable is connected to the PC and the system
– Right IP address and right Control Port are selected in the software
(Configuration
Layout
The main window is splitted into two parts:
– Left side:
– Right side: Information & alarms relevant for MAGIC EEC
Meaning of the LEDs
The LEDs can be displayed in three different colours:
– green: no error
– red: error
– yellow: warning
W i n d o w s
→
Control Interface, see Page 33)
Information & alarms relevant for the Multiplexer connected
to Interface 1
P C
S o f t w a r e
P A G E 2 5
Advertisement
Table of Contents
