Putting The System Into Operation; Mounting; Connection To The Mains Voltage - AVT MAGIC AE1 DAB+ Go Hardware Manual

3 P U T T I N G T H E S Y S T E M I N T O O P E R A T I O N
3.1

Mounting

With its dimensions (W x H x D) of 220 mm x 44,5 mm (1 U) x 220 mm the
MAGIC AE1 DAB+ Go system can be either used as desktop device or
mounted in a 19 inch rack. Corresponding 19" mounting brackets are in-
cluded in delivery.
When mounting the unit please keep in mind that the bending radius of the
cables is always greater than the minimum allowed value.
When the MAGIC AE1 DAB+ Go Telephone Hybrid is installed, please make
sure that there is sufficient air ventilation: It is recommended to keep a spac-
ing of ca. 3 cm from the openings. In general, the ambient temperature of the
system should be within the range of +5 ° C and +45 °C. These limits are espe-
cially to observe if the system is inserted in a rack. The systems works without
ventilation.
TIP
The system temperature can be indicated on the display (
)
During operation air humidity must range between 5% and 85%.
ATTENTION Incorrect ambient temperature and humidity can cause functional defi-
ciencies.
Operation outside the threshold values indicated above leads to a loss of war-
!
ranty claim.
3.2

Connection to the mains voltage

The system can be operated with mains voltage in the range of 90 V and 253 V
via the external power supply adapter included in delivery. The mains fre-
quency can range from 45 Hz to 65 Hz. The maximum power consumption is
15W. The rack must be earthed according to the VDE Regulations. This can be
carried out via the earthing screw on the back side of the unit.
After plugging in the external power supply adapter the unit boots in a few
seconds. In standby mode the level meter/status display is shown on the dis-
play.
P u t t i n g t h e s y s t e m i n t o o p e r a t i o n
P A GE 1 7