Installation; Local Opening/Closing - Salus Connected Wireless System Manual

Section 8
Installation Instructions
This device should be installed by a qualified plumber. Installations and repairs are to be
performed in strict accordance with the requirements of state and local regulating agencies
and codes dealing with plumbing installations.
Step 1. Identify the location
for the Inline Shutoff Valve to
control the desired water supply .
Make sure that the valve is
accessible and there is adequate
clearance for operation of the
Manual Override Lever .
Step 4. Using the SALUS Smart
Home application, close the valve
to be sure it operates correctly
and no interferences exist .
Local Opening/Closing the Inline Shutoff Valve
To operate the valve locally, without the SALUS Smart Home app, press and release the Multi-Function Button .
The chart above describes the resulting actions based on the current state of the valve .
Module 2 – Wireless Accessories
SC904ZB Inline Shutoff Valve
Step 2. Install the valve
using appropriate ¾" NPT
fittings, adapters and thread
sealant . Check for leaks before
proceeding to power the valve .
Step 5. Open the valve using
the app and watch for proper
operation .
Multi-Function
Button
Step 3. Connect the power
adaptor to the jack provided
under the waterproof cap
inserting the cable into the cable
clip
relief to avoid accidental power
disconnection .
Valve State Multi-Function Button Action
Fully Closed Start opening valve
Fully Open Start closing valve
In Motion Stop valve at its current position
Moves valve toward fully open/closed
Partially Open
(opposite of last direction)

. This provides strain
In case of a weak wireless
signal, a wireless repeater
may be required .

8-4