Salus Connected Wireless System Manual page 40

Section 7
Installation Instructions
Place the sensor on a level surface
where water is likely to accumulate
when a leak occurs .
Installing the optional Sensor Cable
Step 1. Fasten the end of the Sensor Cable with the mounting brackets in the desired location . The
brackets can be used for screw mounting to a flat surface or with a wire tie for a below grade sump .
Step 2. Insert the
opposite end of the
Sensor Cable into
the connector on the
Stand .
Module 2 – Wireless Accessories
SS901ZB Water Leak Sensor
If the sensor doesn't lay flat in the desired location, the stand,
which has integral sensing electrodes can be used for a
narrower profile .
Step 3. Tighten the
terminals snugly
taking care not to
overtighten .
Step 4. Mount the stand
on a flat surface using the
double-sided adhesive or
screws provided .
Step 5. Insert
the Water Leak
Sensor into the
Stand .
7-4