Yamaha TRACER MT09TRA Service Manual page 74

TIP
Connecting rod bolt
1. Tighten the bolts to 20 Nm (2.0 m·kgf, 14 ft·lbf)
2. Tighten the bolts further to reach the specified angle 175–185.
TIP
Crankcase bolt (main journal)
1. Lubricate the bolt threads and both sides of the washers with engine oil.
2. Tighten the bolts to 25 Nm (2.5 m·kgf, 18 ft·lbf) in the order shown in the illustration.
3. Fully loosen the bolt "1", and then tighten the bolt again to the specified torque shown below. Repeat
this, one by one, until bolt "8", in the order shown in the illustration.
Tightening torque
Bolts "1" to "6": 15 Nm (1.5 m·kgf, 11 ft·lbf)
Bolts "7" and "8": 18 Nm (1.8 m·kgf, 13 ft·lbf)
4. Tighten the bolts in the order shown in the illustration to the specified angle 60.
2 4
8
5
3 1
7 1
8 4
2-17
TIGHTENING TORQUES
6
7
3 5
2 6