4-6.
5. Adjust:
• Throttle grip free play
Refer to "CHECKING THE THROTTLE
GRIP" on page 3-30.
Throttle grip free play
3.0–5.0 mm (0.12–0.20 in)
EAS30798
CHECKING THE THROTTLE BODY JOINTS
1. Remove:
• Throttle bodies
Refer to "THROTTLE BODIES" on page 7-4.
2. Check:
• Throttle body joints "1"
Cracks/damage Replace.
3. Install:
• Throttle bodies
Refer to "THROTTLE BODIES" on page 7-4.
EAS30799
ADJUSTING THE EXHAUST GAS VOLUME
TIP
Be sure to set the CO density level to standard,
and then adjust the exhaust gas volume.
1. Turn the main switch to "OFF".
2. Simultaneously press and hold the "TCS"
button "1" and "RESET" button "2", turn the
main switch to "ON", and continue to press
the buttons for 8 seconds or more.
TIP
"ECU" appears on the multi-function meter right
display.
3. Simultaneously press the "TCS" button "1"
and "RESET" button "2" for 2 seconds or
more.
TIP
"DIAG" appears on the multi-function meter right
display.
2
4. Press the "TCS" button "1" to select the CO
1
1
5. After selecting "CO", simultaneously press
6. Press the "TCS" button or "RESET" button to
2
TIP
The selected cylinder number appears on the
multi-function meter right display.
• To decrease the selected cylinder number,
press the "RESET" button.
• To increase the selected cylinder number,
press the "TCS" button.
7. After selecting the cylinder number, simulta-
8. Change the CO adjustment volume "3" by
3-10
PERIODIC MAINTENANCE
1
adjustment mode "CO" "2" or the diagnostic
mode "DIAG".
the "TCS" button "1" and "RESET" button "2"
for 2 seconds or more to execute the selec-
tion.
select a cylinder number "3".
1
neously press the "TCS" button "1" and "RE-
SET" button "2" for 2 seconds or more to
execute the selection.
SELECT
2
CO
3
CO
CO
01