Yamaha TRACER MT09TRA Service Manual page 520

Hide thumbs Also See for TRACER MT09TRA:

Table of Contents

Check each switch for continuity with the pocket tester. If the continuity reading is incorrect, check the

wiring connections and if necessary, replace the switch.

Never insert the tester probes into the coupler terminal slots. Always insert the probes from the

opposite end "a" of the coupler, taking care not to loosen or damage the leads.

• Before checking for continuity, set the pocket tester to "0" and to the "  1" range.

• When checking for continuity, switch back and forth between the switch positions a few times.

The switches and their terminal connections are illustrated as in the following example of the main

The switch positions "a" are shown in the far left column and the switch lead colors "b" are shown in the

The continuity (i. e., a closed circuit) between switch terminals at a given switch position is indicated by

There is continuity between red/white, brown/blue and brown/red when the switch is set to "ON".

There is continuity between red/white and brown/red when the switch is set to "P".

ELECTRICAL COMPONENTS

Pocket tester

Analog pocket tester

Chapters

Table of Contents

Tracer mt09traf